The UK's Leading Cricket Specialist
31 Bond Street, Ealing, London W5 5AS
Mon - Sat : 9am - 6pm
EST. 1973
Once you have purchased your bat, it's very important to remember that it must be carefully prepared and looked after. A bat is made from naturally grown willow that has been cared for, for many years and this care must be continued with, for the full life of your bat. You will have paid a lot of money for your bat, so we would like to help you prolong its life and maximise its performance levels. The tips below should help in doing that.
All bats need to be oiled using either raw linseed oil or Owzat cricket bat oil before they are knocked in. A small amount of oil should be applied to the face of the bat with your fingers. It should then be worked into the rest of the blade as well as the toe, edges and back of the bat. The splice area of the bat should not be oiled as this may soften the glue around that area. The bat should then be kept horizontally on its back so as to allow the oil to naturally dry. When the bat has dried out, any oil that has not soaked in should be removed. To do this, fine sandpaper should be used. This process should then be repeated, but please remember that only a small amount of oil must be used.
Oil should be applied as explained above, but only to the back, uncovered edges, and the toe.
It is important that you do not over-oil your bat. More bats are spoilt by over-oiling than by under-oiling.
Many bats are now pre-knocked in. Pre-knocked in however does not mean ready to go immediately. It means that some of the preparation work has been done, but that you will need to complete the final part of the process. We therefore recommend that you spend 4 hours finishing knocking your bat in.
This is best done with a purpose-made bat mallet, either a smooth wooden mallet or a ball-on-handle mallet. Hit the bat firmly with the bat mallet for a short period; don't just tap it. It is important that you make sure that the toe and the edges of the bat are well knocked-in.
After you have finished knocking in the bat, we recommend that you play the bat in gently in a net session. Bat in a defensive manner and attempt to hit the ball with the middle of your bat. A soft, old ball should be used in this initial net session.
In addition to this, we recommend that you take further precautions to make sure that your bat is well protected from being damaged. For uncovered bats, we suggest that you place a clear protective covering over the face of your bat. We can carry this service out for you. It is also advisable that you place a strip of edge tape along the inside and outside edge of your bat to provide additional protection and minimise the chances of cracking the bat on either of these edges.
Of course, it is possible that, despite taking all these precautions, the bat could still break with the first ball that it receives in a match. However, if you carry out all of the instructions above, you will greatly reduce the chances of any damage being caused to the bat. The bat is made of wood and is a natural product and therefore there is no guarantee that the bat will not break. Superficial surface cracks can occur, but these should not detract from the performance of the bat.
All cricket bats stocked by VKS are of the highest quality and a great deal of care is taken to make sure that only the best products are sold to our customers. Nonetheless, we accept that sometimes bats can be damaged soon after they are purchased. In circumstances where damage is caused to your bat or if you are unhappy with the performance of the bat, we recommend that you inform us of the problem immediately. Your bat will then be inspected and we will advise you of the action to be taken.
